GPS positioning manufacturers introduce the composition of satellite positioning systems.Dog gps tracker Manufacturing

　　1. Space part

　　The space part of GPS is composed of 24 working satellites, which are located 20 200 km above the earth's surface, evenly distributed on six orbital planes (four for each orbital plane), and the Orbital inclination is 55 °. In addition, there are four active backup satellites in orbit. The distribution of satellites enables the observation of more than 4 satellites anywhere and at any time in the world, and maintains a geometric image with good positioning and calculation accuracy. This provides continuous global navigation capabilities over time. The GPS satellite generates two sets of codes, one of which is called the C/A code (Coarse/Acquisition Code 11023MHz); A group called Procise Code (10123MHz) is controlled by the US military due to its high frequency, low interference, and high positioning accuracy. It has a password and cannot be interpreted by ordinary people, mainly serving the US military. After deliberately reducing the accuracy of the C/A code through measures taken, it is mainly open for civilian use.

　　2. Ground control part

　　The ground control section consists of one main control station, five global monitoring stations, and three ground control stations. The monitoring stations are equipped with precision cesium clocks and receivers that can continuously measure all visible satellites. The satellite observation data obtained by the monitoring station, including ionospheric and meteorological data, will be preliminarily processed and transmitted to the main control station. The main control station collects tracking data from various monitoring stations, calculates the satellite's orbit and clock parameters, and then sends the results to three ground control stations. The ground control station injects these navigation data and main control station commands into each satellite as it reaches the sky. This injection is performed once a day on each GPS satellite and the final injection is performed before the satellite leaves the injection station's operational range. If a ground station malfunctions, the navigation information stored in the satellite can still be used for a period of time, but the navigation accuracy will gradually decrease.

　　3. User Equipment Section

　　The user equipment part is the GPS signal receiver. Its main function is to capture the selected test satellites according to a certain satellite cutoff angle and track their operation. After the receiver captures the tracked satellite signal, it can measure the pseudo distance and the rate of change of distance from the receiving antenna to the satellite, and demodulate data such as satellite orbit parameters. Based on these data, the microprocessor in the receiver can perform positioning calculations according to the positioning solution method, calculating the longitude and latitude, height, speed, time and other information of the user's geographical location. The receiver hardware, onboard software, and GPS data post-processing software package constitute a complete GPS user device. The structure of a GPS receiver is divided into two parts: an antenna unit and a receiving unit. The receiver generally uses two types of DC power sources, internal and external. The purpose of setting up the internal power supply is to continuously observe without interruption when replacing the external power supply. The battery automatically charges when using an external power source. After shutting down, the internal battery supplies power to the RAM memory to prevent data loss. Various types of receivers are becoming smaller in size and lighter in weight, making them easy to observe and use in the field.

Read recommendations:

gps tracker with magnet

4G GPS Tracker Factory

G500L -4G OBD GPS Tracker

Two frequencies can eliminate ionizing layer errors.Portable car gps systems Manufacturing

The following aspects mainly affect the performance of GPS antenna